Презентация на тему Monitoring of air temperature, humidity, and CO2 concentration

report a monitoring activity
Physical quantities to be measured:
Air

temperature and relative humidity
Absolute humidity should be calculated
Optional: CO2 concentration
Alternative 1: Using data loggers for monitoring:
Data logger EBI 20, that should be programmed by means of a PC
Monitoring of air temperature and humidity
You should use at leat two data loggers
Alternative 2: Using a Grant squirrel multichanel data logger
Monitoring air and surface temperatures at 8 locations
The data logger is used together with a portable PC (available in the lab)
Sampling duration:
At least 24 hours
Groupwork:
One or two students in the group (monitoring of temperature and humidity)
Two students in the group (monitoring of temperature, humidity and CO2 concentration)

concentarions later in this course
You could measure the air

flow rates in the room in which you do the monitoring, however you need to learn how to measure
You could compare the measured air flow rates to the design values in D2
If you monitor also CO2 concentrations, and know the number of persons present, you could do some further analysis of the ventilation in the room

what kind of variation you could expect in temperature

and humidity * Constant values are not very interesting results

measured data (temperature and humidity takes two)

The unit provides

different recording modes
The desired recording mode is set by the PC
Endless measurement
Immediate measurement until memory is full
No measurement/start by pressing key
Start/stop measurement

data loggers that you have, may show different values

for temperature and humidity
You should correct for that difference, when you analyze your sampling data
This is how you should do:
When you are starting your sampling, put the loggers first at the same location (at a table side by side) and let them be there for an hour
Use this data to correct the results so that your loggers show the same results at the same location

long cabel
Suggestions for measuring activities:
Do a comparison of the

sensors, since this data logger is new and we do not yet have information about its characteristics.
Study operative temperature, since one of the sensors could be installed inside a globe thermometer.
Study the efficiency of the heat recovery of Building A by monitoring the temperatures in various locations in the air handling unit.

variations?

of February:
Each group tells, what and where they are

going to monitor
Reserving the data loggers:
Send an e-mail to the laboratory engineer keijo.piirainen@xamk.fi to reserve the loggers. Tell in the e-mail about which instruments you need, when you want to get the instruments and instructions to use them, and when you will return them.
Save the monitoring results to your own memory stick
You need to do a PowerPoint file which has to be returned on the 19th of March in Moodle (detailed instructions for the report will be given later)

presentations are held on Tuesday the 21st of February
The

data should be shown in averages and in graphs (done with Excel)
Absolute humidities should be calculated and shown together with the air temperature and relative humidity
CO2 concentrations should be shown
Photos of the monitoring are desirable

in different rooms
Residence, conditions at different heights
Conditions inside a

refrigerator or freezer
Class room, conditions during the day, at different heights or at different locations in the room
Something else that interests you? Swimming hall, gym, department store…
Conditions inside a car

When you put the data logger outside, make sure that it does not get wet (snow, rain…) or stolen.